FAQ’s

How do I repair a hole in drywall?

Repairing a hole in drywall is relatively simple and only takes a few steps!

1. Cut back drywall to studs or install backing.
2. Install drywall patch with screws to match drywall width (½”, ⅝”, etc.).
3. Tape all joints and corners.
4. Coat joints, corners, and screws two times.
5. Sand coating after each coat dries.
6. Texture finish to match the existing texture. Once dry, sand and blend to prepare for paint.

How do I mud drywall?

Begin by purchasing a drywall pan, knife, and drywall tape. You will start this process by applying tape to all joints and corners. We recommend paper tape for corners and mesh tape for remodel DIYs. After you have finished prepping the area, place the mud in your pan and then use the knife to mix the mud until you reach the right consistency. Make sure to apply drywall mud with even coats and once the mud has dried sand down any edges and a field of coating mud in between coats.

How do I remove patches of drywall?

1. Find the studs that frame the outside of the prospective patches.
2. Cut existing drywall halfway between the existing wood studs.
3. Remove necessary drywall and pull any existing nails and screws.
4. Install screws in the remaining and new drywall patch.

How much drywall do I need?

Drywall sheets come in various sizes such as 4’x8’, 4’x10’, and 4’x12’. To determine what size you need, simply calculate the length and width of the area to determine the amount of square footage you are dealing with.

How much is drywall?

Drywall typically ranges between $10 – $20 a sheet, depending on size and width. If you need specialty drywall to accommodate for sound or moisture, the price can increase up to $85 a sheet.

How to replace drywall?

1. Find the studs that frame the outside of the prospective patches.
2. Cut existing drywall halfway between the existing wood studs.
3. Remove necessary drywall and pull any existing nails and screws.
4. Install screws in the remaining and new drywall patch.

What drywall to use?

Depending on where and what project you are working on, some drywall is better than others.

• Patches: Use the width of drywall to match the existing
• Walls w/ water pipe stub outs: Use Mold Curb
• Walls w/ tile or shower stall: Use fiberglass sheathed gypsum (We use Dens Shield or Dens Armor, Respectively)
• Most ceilings: use ⅝” drywall